Mining company-Lockout Tagout

Mining company Lockout Tagout

“The material quantity is very large, so it is necessary to do a good job of inspection and operation to avoid failure shutdown and ensure that the liquid quantity passes through… Do a good job in mutual insurance, strictly abide by safety rules and regulations…” At the pre-class meeting, the monitor of the filter press workshop of the mining company made targeted arrangements for today’s work.
After the meeting, he, who watched everyone go to the post, came to the belt mouth to carefully observe the state of the material falling from the mouth, and made a judgment on the moisture of the filter cake, and then informed the filter press post through the intercom to “increase the feeding time by 50 seconds”, to observe the material “dry shrinkage”, he left the mouth. Came to the first floor, but saw two colleagues are in accordance with the arrangement of the pre-shift meeting to clean up the car wash pool. At this time, a colleague is holding a plough to clean the floating plastic bags, foam board and other debris, the monitor quickly rushed to the past and colleagues slowly put the submersible pump into the bottom of the pool, and then open the submersible pump. Seeing the smooth discharge of the submersible pump, the monitor asked them to “open the water gun in time after the liquid level in the pool falls down, wash the mud at the bottom, and ensure that the silt at the bottom of the pool is cleaned up”. At this point, the monitor, who was sweating on his forehead, returned to the duty room and just wanted to take a drink of water. He looked up and found that the signal on the screen of the main control room showed that the 6# filter press had stopped. “What’s the matter? This 6# filter press filter is the sintering method of red mud, is the key test project of the company, can not easily stop “. Just want to ask, the voice of colleagues on the intercom, “report to the monitor, 6# filter press found a rag”. “Replace it immediately!” After the monitor made the instructions decisively, he did not drink the water. He ran to the third floor at the first time and began to change the press cloth with Wang Weidong and Zhang Jianguo. “Pay attention not to step on the empty foot”, “hanging rope check again”, “Lockout tagout for power failure of feed pump”…… The monitor will remind or put forward the requirements in time, while hanging the plate, disassembling the cloth, cleaning the knot on the plate and covering the cloth, and take the lead to jump down and tighten the press plate screws of the press cloth…… Looking at the 6# filter press and smooth open up, monitor this just a sigh of relief.