Rectification operation violation behavior

Hine law

For every serious accident, there are 29 minor accidents, 300 near-misses and 1,000 potential accidents.

According to the statistical analysis of the accident, there are few objective factors, few equipment factors, and most of them are human factors: there are paralysis and fluke mentality, weak safety awareness, reduced behavior standards, the site management personnel lack of correct understanding of safety production, safety responsibility system is not implemented, there are “two sides” phenomenon between system and implementation.
Rectification and management of violations include:
Whether there are rules and regulations affecting production safety or obvious violations, whether production safety risk identification and prevention and control are organized as required.

Whether the process, equipment, design, plan, etc. are changed, whether the change procedure is strictly implemented, whether the change risk is identified and controlled.

Whether there is forced to risk illegal operations, arrange people without corresponding qualifications to engage in dangerous operations, whether there is knowingly committed, not follow the rules, there is more than order, inaction and disorderly acts.

Whether to confirm the qualification and ability of the contractor’s key personnel, whether to carry out safety analysis and confirm safety measures before work in high-risk operations, whether to strictly implement the work permit system, whether to implement the requirements of on-site supervision.

Whether to confirm the ability of safe operation, post risk prevention and control, emergency response, etc.

Rectification of operation violations include:
Whether there is a violation of the operation rules, construction plan, operation process, work steps and other requirements of the behavior.

Whether to wear and use effective labor protection equipment according to regulations.

Whether there is off guard, sleep guard, drunk on guard and other behaviors.

Whether the standby, idle or to be scrapped process equipment or inspection and maintenance are effectively purged and replaced, energy isolation, status identification, Lockout tagout.

Whether the roving inspection system is strictly implemented, and whether the abnormal situation, leakage, alarm, risk, hidden trouble found in the work that obviously affects the production safety are reported and dealt with in time according to the regulations.